Starting And Stopping The Hdlm Manager; Starting The Hdlm Manager - Hitachi XP P9500 User Manual

Also, you can view information for each HDLM component. Execute the
dlnkmgr command's view operation with the -sys and subsequent parameter
specified. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -adrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -pdrv

Starting and Stopping the HDLM Manager

If an error occurs in the system, such as in an HDLM program, you may need
to manually stop or start HDLM to recover from the error.

Starting the HDLM Manager

To start the HDLM manager, log in to Linux as a user with root permissions
and then execute the following command.
# /etc/init.d/DLMManager start
Starting DLMManager:
Lower case characters can be used for the command name (dlmmanager).
# /etc/init.d/dlmmanager start
Starting DLMManager:
The startup script that was set up during HDLM installation runs, and starts
the HDLM manager.
Note
¢
¢
Important
Use one of the following procedures to confirm that the HDLM manager is
active:
When you start the HDLM manager immediately after stopping it,
confirm that the HDLM manager has stopped (Dead is displayed when
executing /opt/DynamicLinkManager/bin/dlnkmgr view -sys -
msrv), and then start it.
Even if the HDLM manager is running, Dead might be displayed when
you execute /opt/DynamicLinkManager/bin/dlnkmgr view -sys -
msrv. If this happens, see
5-7.
When stopping the HDLM manager, even if a message indicating that
the HDLM manager has successfully stopped, it takes a few seconds
more to stop processes. Therefore, if you start the HDLM manager
immediately after stopping it, the HDLM manager is regarded as being
started, and a message indicating that the HDLM manager has
successfully started is output. However, starting of the HDLM
manager is cancelled, and it will remain inactivate.
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Linux(R))
What To Do for the Program Error on page
[ OK ]
[ OK ]
4-19