Cub Cadet 17WI2ACK056 Operator's Manual page 26

The position on the rear deck rollers is generally not changed. In
the low position the rollers will roll the grass. In the high position,
the rollers are in a storage position and do little or no rolling of
the grass. Change the roller position as follows:
1. Remove the cotter pin from the left end of the roller shaft.
See Fig. 6-8.
High
Position
Cotter
Pin
\
Roller _'_ _ "
Low Position
Roller Shaft
Right Rear
Roller Bracket
J
Figure 6-10
2. Slide the roller shaft to the right and remove the rollers
as the shaft is fully withdrawn from the right rear roller
bracket. See Fig. 6-8.
3. Insert the roller shaft through the other roller bracket hole.
Slide the rollers onto the shaft as you slide the shaft to the left.
4. If necessary, rotate the roller shaft to align the flat area on
the left end of the shaft with the flat of the hole in the left
roller bracket. Slide the shaft through the left roller bracket
and secure with the cotter pin.
SECTION 6-- MAINTENANCE & ADJUSTMENTS