Table of Contents
Advertisement
Setting 6: TRANSACTION REPORT PRINT SELECT
This sets the condition for printing out a Transaction Report. Enter a
number from 1 to 5 as follows:
1 (ALWAYS PRINT): A report will be printed after each
2 (ERR/TIMER/MEM): A report will be printed after an error, timer
3 (SEND ONLY):
4 (NEVER PRINT):
5 (ERROR ONLY):
Initial setting: 5
FUNCTION
4
Enter a number
from 1 to 5
Setting 7: DIAL MODE
This sets the mode of dialling. Press 1 if you are on a tone dial line, or 2
if you are on a pulse dial line.
Initial setting: 1
FUNCTION
4
TONE
PULSE
or
1
Note: For all units installed in New Zealand, select "1" for tone dialling. The
pulse setting "2" will not operate correctly and must not be used.
transmission, reception, or error.
operation, or memory operation.
A report will be printed only after a
transmission.
A report will never be printed.
A report will be printed only after an error
occurs.
until
Press
display
shows:
DIAL MODE
until
display
Press
shows:
2
PSEUDO RING DUR.
Option Settings
TRANSACTION LIST
STOP
DIAL MODE
STOP
117
Advertisement
Table of Contents
