Sending A Fax; G Basic Procedure For Sending Faxes; Basic Procedure For Sending Faxes - Sharp AR-FX10 Operation Manual

SENDING A FAX

BASIC PROCEDURE FOR SENDING FAXES

1 Make sure the machine is in fax mode.
scanner option is installed, touch this key to return
to the initial screen of fax mode or scanner mode,
whichever mode was selected last. To switch to
fax mode from scanner mode, touch the
[SCANNER/FAX] key (see
2 Load the original.
G Using the reversing automatic document feeder:
Page 1-7
G Using the document glass: Page 1-7
If you are using the document glass to send
multiple pages, load the first page first.
NOTE
You cannot load documents in both the document
feeder tray and on the document glass and send
them in a single fax transmission.
3 Check the original size.
EXPOSURE
STANDARD
RESOLUTION
AUTO A4
ORIGINAL
If the original is not a standard size or the size was
not detected correctly, touch the [ORIGINAL] key
to specify the original size. (See "MANUALLY
SETTING THE SCANNING SIZE" on page 1-8.)
4 If needed, adjust the resolution setting.
(Refer to page 1-9.)
OSU
STANDARD
RESOLUTION
AUTO A4
ORIGINAL
2-2
When the [IMAGE
SEND] key light is on,
the machine is in fax
mode. If the light is not
on, press the [IMAGE
SEND] key.
When the network
on page 1-4).
8
If the address directory
screen appears, touch
the [CONDITION
SETTINGS] key to
display the condition
settings screen (page
1-5).
5 If needed, adjust the exposure setting.
(Refer to page 1-10.)
AUTO
EXPOSURE
STANDARD
RESOLUTION
AUTO
ORIGINAL
6 Dial the fax number.
number. You can also use the [REDIAL] key (page
1-11) or an auto-dial number (following page).
Entering a pause.
PAUSE NEXT ADD
FAX MEMORY:100%
ADDRESS
AUTO RECEPTION
DIRECTO
SUB ADD
Each time you touch the [PAUSE] key, a hyphen
("-") appears and a 2-second pause* is inserted.
The [PAUSE] key is also be used to link numbers
together (this is called chain dialing). Enter a
number, touch the [PAUSE] key to enter a hyphen
"-", and then enter another number with the
numeric keys or by pressing a one-touch key. The
linked numbers will be dialed as one number.
* The duration of each pause can be changed with
the key operator program. ("Pause time setting"
on page 8-5.)
The number that you
entered appears in the
message display (See
"Condition settings
screen" on page 1-4.). If
it is not correct, press the
[C] key and re-enter the
If you need to insert a
pause between digits
when dialing out from a
PBX or when dialing an
international number,
touch the [PAUSE] key
in the upper right corner
of the screen.