Table of Contents
Advertisement
PROGRAMMING
THE REMOTE
CONTROL
Programming the Remote Control
The Universal
Remote
Control
can be programmed
to operate
many manufacturers'
components
using the component
function
buttons
for VCR, DVD, AUX, RCVR, DTV,
TV, CBL, or DBS. Follow the procedures
for programming
your Remote
Control
with
and without
codes for the component.
Determine
the manufacturer
of the component
and look in the table for the code.
Note:
Be careful to press ACTION in the middle of the button. If you do not press in the
middle of the button, the arrow buttons may be activated.
This will interrupt your
programming.
Programming
With Code
•
Confirm
that the external
component
is plugged
in and is turned
on.
•
Turn the component
off.
•
Press the ACTION
and POWER
button,
together,
for at least 5 seconds.
All
mode buttons
will flash, then let go of the buttons.
•
Press
appropriate
component'button
(VCR,
CBL,
etc.)
on
the
Remote
Control.
The pressed
button
will illuminate
steadily.
All other
buttons
will go
out.
•
Enter the 3-digit component
code using the Remote
Control
numeric
keypad
(0 ~ 9 buttons).
If a proper code was entered,
the mode button will blink twice
and go out.
•
Press
the
Remote
Control
POWER
button
to test the component.
If the
procedure
was successful,
the component
will turn on.
_
_ _;_unsuccessful
Code
If the component does not operate with the Remote Control,
repeat the procedure using another code. (Some
brands have multiple codes.)
If an incorrect code is entered, or if the procedure takes longer
than 30 seconds, the programming will fail.
Programming
Without
Code
This procedure searches all codes and is called the "sequence
method".
•
Confirm that the external
component
is plugged
in and is turned on.
•
Turn the component off.
•
Press the ACTION
and POWER
button,
together, for at least 5 seconds.
All
mode buttons will flash, then let go of the button.
•
Press appropriate
component
button on the Remote
Control. The pressed
button will illuminate. All other buttons will go out.
•
Press the D, button to move forward to the next code. Press the _1 button to
move backward.
•
Press the Remote
Control
POWER
button to test the component.
If the
procedure was successful, the component will turn on.
Note:
Repeat the preceding two steps until the component code is found. It may take many attempts
before the correct code is found.
•
After the code is found, press the ACTION
button to store the code.
[]
Advertisement
Table of Contents
