Samsung SRP-275 User Manual page 19

• Memory Switch 8
Switch
1 Upside down
2 Font Selection
3 Selection Paper End Buzzer
4 Reserved
5 Selection of the cover open status
6 Buffer Size
7 Receive buffer full release
8 Printer (Cover open during operation)
NOTES
MSW 8-5:
When Off is selected, a bit of the "paper end sensor" in each status that is transmitted from the printer is
changed every time the rear cover is open or closed. When On is selected, a bit of the "rear cover open /
close" in each status that is transmitted from the printer is changed every time the rear cover is open or
closed. When you replace a SRP-270 with a SRP-275, you should adjust the MSW 8-5 to Off.
MSW 8-8:
When Off is selected, a bit of the "automatic recoverable error" in each status that is transmitted from
the printer is changed every time the rear cover is open. When On is selected, a bit of the "mechanical
error" in each status that is transmitted from the printer is changed every time the rear cover is open.
The setting of MSW 8-5 and 8-8 can be set by "Memory Switch setup mode".
• Customize value
Function
Paper roll width 57.5 mm / 69.5 mm / 76 mm (default value)
NOTES
These setting can be set by "Memory Switch setup mode."
• Serial communication
Function
baud rate
Parity
Handshake
Data length
NOTES
There are two methods, DIP Switch and Memory Switch, to adjust the serial communication conditions.
DIP Switch 1-5 selects which is effective, DIP Switch or Memory Switch.
To enable the "Serial communication" setting, you have to adjust the "Serial interface selection" function
of DIP Switch 1-5 to "Memory Switch".
These settings can be set by "Memory Switch setup mode".
Rev. 1.03
Function
Selectable value
Selectable value
2400 bps
9600 bps
None
Even
DSR/DTR
7 bit
On
On
Font B
Off
Cover open
40 bytes
Remaining 522 bytes
Errors that can
possibly recover
4800 bps
19200 bps
Odd
-
XON/XOFF
8 bit
- 19 -
SRP-275
Off
Off
Font A
On
Fixed to Off
Paper end
8 Kbytes
Remaining 640 bytes
Errors that
automatically recover