Operation; Trigger Lock; Pressure Relief Procedure - Graco X5 Operation Operation Manual

Operation

Operation

Trigger Lock

Always engage the trigger lock when you stop
spraying to prevent the gun from being triggered
accidentally by hand or if dropped or bumped.
ti8923a
Trigger Locked (SG10)
ti8908a
Trigger Locked (SG20)

Pressure Relief Procedure

Follow this Pressure Relief Procedure whenever
you stop spraying and before cleaning, checking,
servicing, or transporting equipment.
1. Turn power switch OFF and unplug
power cord.
Pressure Control Knob Settings
High Pressure
Spray
To select function, align symbol on pressure control knob with setting indicator on sprayer.
312001G
ti8922a
Trigger Unlocked (SG10)
ti8909a
Trigger Unlocked (SG20)
ti2810a
Low Pressure
Spray
2. Turn Prime/Spray valve to
PRIME to relieve pressure.
3. Hold gun firmly to
side of pail. Trigger
the gun to relieve
pressure.
4. Engage trigger
lock.
Leave Prime/Spray valve in the PRIME
position until you are ready to spray again.
If you suspect the spray tip or hose is clogged or
that pressure has not been fully relieved after fol-
lowing the steps above, VERY SLOWLY loosen tip
guard retaining nut or hose end coupling to relieve
pressure gradually, then loosen completely. Clear
hose or tip obstruction. Read Unclogging Spray
Tip, page 13.
Prime/ Rolling
Clean
ti9346a
ti9207a
ti8923a
ti8908a
(SG10) (SG20)
ti5597a
9