Mounting Saw To Workbench - Craftsman 113.298090 Owner's Manual

assemb|y
4. Lay a straight piece of wood or a framing square on
table to act as a straightedge. If outer edge of
extension is higher of lower than the table surface:
A. Slightly loosen nuts holding bracket to extension
using 7/16 in. wrench.
B. Move end of extension up or down until outer edge
is even with table surface. Check with Guide Bar.
Tighten nuts.
C. Re-check INNER edge of extension to make sure
it has not moved. Readjust, if necessary.
BOTH MODELS
1. From among loose parts, find:
1 Wire Tie
2. Snap wire tie into 1/4 inch hole in right side of
cabinet. Route motor cord from inside cabinet
through the wire tie. Secure cord in wire tie. Keep
any extra cord on outside of cabinet. Do not push
extra cord inside cabinet.
EXTENSION REMOVED FOR
PICTURE CLARITY
V WIRE TiE
BOTH MODELS
MOUNTING YOUR SAW TO A
WORKBENCH
1/2
To mount the saw on workbench, make sure that there
isan o_ning inthe top of the bench the same size as the
opening in the bottom of the saw so that the sawdust can
drop through. Recommended working height is33 to 37
inches form the top of the saw table to the floor.
NOTE: All dimensions in inches.
4 HOLES
7/16 DIA.
FRONT OF SAW
26