2. Place the sawontop ofthelegsetsothatthe baseof
thesawlinesupapproximately evenwiththeoutline of
thetopofthelegset.
3. Frombeneath thesawyouwill be abteto locateand
lineupthe fourmounting holesof the saw basewith
the propermounting holesof the saw basewiththe
proper m ounting holesinthe
leg set assembly.
4. Place one flat washer onto each of the four hex head
screws and insert them into each of the mounting
holes. Be sure the screws go through
the saw base
holes and the leg set mounting holes.
5. Install a flat washer, Iockwasher, and a hex nut on
each of the four screws and tighten securely.
6. Level the saw to your requirements
by adjusting the
leveling feet. Lock leveling feet into position.
7. Securely tighten all leg set screws and nuts.
SAW BASE
[
HEX HEAD
SCREW
""_._|
FLAT
WAS
HER
--""_c_
1
END
LOCKWAS"E"
17
L
BOTH MODELS
INSTALLING
BEVEL
POINTER
AND HANDWHEELS
1. From among the loose parts, find the following hard-
ware:
1 Bevel Pointer
* 1 Screw, 8-32 x 3/8
2 Handwheels
2 Screw, Phillips 10-32 x 5/8
*2 Lockwasher, External 3/16
Items marked with an asterisk (*) are shown actual size.
BEVEL POINTER
HANDWHEEL
8-32 x 3/8 SCREW
10-32 x 5/8
PHILLIPS SCREW
©
3/16 IN.
LO CKWASHER
2. Fasten bevel pointer to cradle assembly
with 8-32 x
3/8 screw, as shown. Adjustment of the pointer may
be necessary later.
3. Push handwheels
onto shafts, as shown,
and fasten
each with a 10-32 x 5/8 phillips screw and Iockwasher.
LOCKWiSHE
i ER
TILT
HANDWHEEL
ELEVATION
HANDWHEEL
!3