Table of Contents
Advertisement
assembly
BOTH MODELS
ASSEMBLY
OF STEEL LEG SET
Assembly is best done in the location where the saw will
be used.
1. From among the loose parts, find the following hard-
ware:
4 Leveling Feet
*8 Hex Nuts, 3/8-16
*24 Truss Head Screws, 1/4-20 x 1/2
*24 Hex Nuts, 1/4-20
*24 1/4 Externa| Lockwashers
LEVELING
FOOT
items marked with an asterisk (*) are shown actual size.
R_v
3/8-16 HEY, NUT
@
114-20 HEX NUT
114-20X1/2 IN.
TRUSS HEAD SCREW
1/4 IN. EXTERNAL
LOCKWASHER
2. Insert three truss head screws through the three
holes near the top of one Leg. Place the Side Stiffener
up to the Leg, as shown, sothat the three screws line
up with the holes in the Side Stiffeners marked with an
"X" in the illustration.
3. Place a Iockwasher and hex nut on each screw and
finger tighten the hex nut.
4. Following the same procedure as above, continue to
fasten together the remaining Legs and Stiffeners as
illustrated.
5. Install one 3/8-16 hex nut on each of the Leveling
Feet.
6. Insert a Leveling Foot through the hole inthe bottom
of each Leg so the Leveling Foot pad rests on the
floor.
7. Install another 3/8-16 hex nut on each ofthe Leveling
Feet.
8. Set leg set upright on floor and securely tighten all
nuts.
9. After complete assembly, you may level the saw by
moving the lower nut up or down along the threaded
stud of each Leveling Foot. The upper nut is used to
lock the Leveling Foot into position when the saw is
level.
END
STIFFENER
,
,
IL
i
MODEL 113.226880
ONLY
MOUNTING
YOUR SAW TO THE LEG SET
(Model
113.298090
will be mounted
later)
1. From among the loose parts, find the following hard-
ware.
*4 Hex Head Screws, 5/16-18 x 1-1/4
*4 Hex Nuts, 5/16-18
*4 Lockwashers, 5/16 In. External
*8 Fiat Washers, 11/32 x 11/16 x 1/16
Items marked with an asterisk (*) are shown actual size.
3/8 IN. HEX NUTS
LEVELING
FOOT
5116-18 x 1-1/4
HEX HEAD SCREW
5/16 IN. EXTERNAL
LOCKWASHER
5/16-18 HEX NUT
11132 IN. I.D.
FLAT WASHER
12
Hide quick links:
Advertisement
Table of Contents
