Leveling The Deck (Side To Side); Parking Brake Adjustment; Steering Adjustment - Cub Cadet LTX 1050 Operator's Manual

Leveling the Deck(Sideto Side)
If the cutting deck appears to be mowing unevenly,a side to side
adjustment can be performed. Adjust if necessary as follows:
1. With the tractor parked on a firm, level surface, place the
deck lift lever in the middle position and rotate both blades
so that they are perpendicular with the tractor.
2. Measure the distance from the outside of the left blade
tip to the ground and the distance from the outside of the
right blade tip to the ground. Both measurements taken
should be equal. If they're not, proceed to the next step.
3. Loosen, but do NOT remove, the hex bolt on the left deck
hanger bracket. See Fig. 6-6.
...................................... /
\
\
Figure 6-6
4. Using a wrench, raise or lower the left side of the deck by
turning the adjustment gear. See Fig. 6-6.
The deck is properly leveled when both blade tip measurements
taken earlier are equal. Retighten the hex bolt on the left deck
hanger bracket when proper adjustment is achieved.
Steering Adjustment
If the tractor turns tighter in one direction than the other, or if
the ball joints are being replaced due to damage or wear, the
steering drag links may need to be adjusted.
Adjust the drag links so that equal lengths of each are threaded
into the ball joint on the left side and the ball joint on the right
side:
1. Remove the hex nut on the top of ball joint. See Fig. 6-7.
2.
3.
Front
1.
Parking BrakeAdjustment 2.
If the tractor does not come to a complete stop when the brake
pedal is completely depressed, or if the tractor's rear wheels can
roll with the parking brake applied (and the hydrostatic relief 3.
valve open), the brake is in need of adjustment. Seeyour Cub
Cadet dealer to have the brake properly adjusted.
Adjusting the Seat 4.
Refer to the Set-Up a nd Assembly section of this manual for seat
adjustment instructions.
Warning! Before operating the tractor, make sure the
seat is engaged in the seat-stop. Engage the parking
brake. Stand behind the machine and pull back on
seat until it clicks into place.
Figure 6-7
Thread the ball joint inward to shorten the drag link.
Thread the ball joint outward to lengthen the drag link.
Replace the hex nut after proper adjustment is achieved.
NOTE:Threading the ball joints too far onto the drag links
will cause the front tires to "toe-in" too far. Proper toe-in is
between 1A6" a nd sad'.
tire toe-in can be measured as follows:
Place the steering wheel in position for straight ahead
travel.
In front of the axle, measure the distance horizontally from
the inside of the left rim to the inside of the right rim. Note
the distance.
Behind the axle, measure the distance horizontally from
the inside of the left rim to the inside of the right rim. Note
the distance.
The measurement taken in front of the axle should be
between lad' and sad'lessthan the measurement taken
behind the axle.
SECTION 6 -- MAINTENANCE & ADJUSTMENTS
23