Epson ActionLaser 1300 EPL-3000 Service Manual page 88

Maintenance
4. Set the imaging cartridge on a clean, flat surface. Firmly grip the tab on the left side of the
cartridge. Pull the clear seal all the way out with fiw even pressure, as shown.
5. Shake the imaging cartridge again.
6. Insert the imaging cartridge into the printer by placing the pins on each side of the cartridge
into the grooves inside the printer. Slide it gently into the opening until it stops.
7. Push down on the front of the cartridge until it locks in place
Figure Imaging Cartridge Settings -1
6-3.
8. Close the upper unit.
9. If the printer displays toner low message, hold down the Continue button together with the
Toner Save Mode button until the Status Sheet light begins blinking green and orange.
6-2
Figure 6-2. Removing the Clear Seal
Figure 6-4. Imagin Ca~idge
Settings -
Rev. A