EPL-3000 /Action Laser 1300 Service Manual
3.2.3 Disassembling the Engine
This section describes disassembling the engine, including the power supply board (PWB-E).
3.2.3.1 Optical Unit Removal
Do not open the unit under any conditions.
Do not remove the circuit boardfiom the optical unit under any condition.
1.
Remove the housing. (Refer to Section 3.2.1.1.)
2.
Disconnect connector CN205 on the main board.
3. Remove 2 CC screws (M3 x 6) and CC screw (M3 x 12), and remove optical unit.
3.2.3.2 Fusing Unit Removal
1. Remove the housing. (Refer to Section 3.2.l.l.)
2. Remove the main board. (Refer to Section 3.2.2.l.)
3. Remove 4 CP(0) screws (M3 x 6) on the fusing unit, and remove the fusing unit.
Rev. A
Figure 3-5. Removing the Optical Unit
Figure 3-6. Removing the Fusing Unit
Disassembly and Assembly
3-7