Service Mode; Hexadecimal Dump Mode; Eeprom Format Mode - Epson ActionLaser 1300 EPL-3000 Service Manual

Buttons
Status Sheet
Warning Measures
Feed
Continue
Status Sheet Printing
Toner Save Mode
Reset
Toner Counter Reset (Toner Save Mode+ Status Sheet)
Toner Counter Reset

1.4.2 Service Mode

This printer has three service mcdes as follows:
Hexadecimal Dump
Factory Reset

1.4.2.1 Hexadecimal Dump Mode

The hexadecimal dump mode is a useful tool for troubleshooting data control problems. To enter
hexadecimal dump m~e, turn on the printer while holding down the Toner Save Mode button
until Data light comes on.
1.4.2.2 Factory Reset Mode
This mode resets all settings except the printer name and total printing counter. To enter factory
reset mode, turn on the printer while holding down the Toner Save Mode button until only the
Toner Save Mode light is on.

1.4.2.3 EEPROM Format Mode

replaced. These operations are specified in the documentation accompanying these components.
printing counter, and other settings) are all stored in memory.
Defaults for the EEPROM format functions can be written to EEPROM as follows:
Turn on the printer while holding down the Status Sheet and Toner Save Mode buttons until only
the Data light is flashing.
The printer name (EPL-3000 or ActionLaser 1300) and default paper size (A4 or letter) are
Note:
selected by jumper J3 for the main controller board when this operation is performed.
Rev. A
When the Jam/Cover light is quickly flashing, press this button to
clear a warning.
When the Data light is slowly flashing, press this button to print out
data in the printer's memory.
When the Jam/Cover light is slowly flashing, press this button to
starts printing.
When the Data light is on, press and hold this button until the Data
light begins quickly flashing. A status sheet will them print.
Press this button to turn the Toner Save Mode light on (Toner Save
Mode selected) or off (Toner Save Mode not selected), or to reset
Toner Save Mode.
Press and hold down this button until the Toner Save Mode light
begins flashing.
To reset the toner counter, press and hold down the Toner Save
Mode and Status Sheet buttons until the Data light turns green and
then flashes orange.
General Description
1-17