Panasonic AG-HPD24PJ Operating Instructions Manual page 23

• When recording 720p with an HD
reference or no reference input, the
recorded phase may be shifted from the
input signal.
• When the SETUP - SYSTEM - FREQUENCY
menu setting is 59-23 or 60-24, the HD
reference signal can only synchronize
playback.
5.
VIDEO OUT jack
Provides analog composite video signal
output.
No signal is output when the SETUP -
SYSTEM - FREQUENCY menu setting is
24 Hz or 60-24.
In both 3D REC/PB and SYNC PB modes, the
sync signal output here is exclusively for use
by another AG-HPD24.
➝
( "3D Signal Recording and Playback"
➝
page 38, "Synchronous Playback" page
48)
6.
HD/SD-SDI IN/OUT jacks
These provide input and output of serial
digital component audio/video signals.
◆ NOTE:
• Use 5C-FB or equivalent double-shielded
cable for connections.
7.
HDMI OUT port
Connects to a monitor or TV using an HDMI
cable. In 3D REC/PB and SYNC PB modes,
3D video can be displayed by connecting a
3D monitor.
(➝ "3D Signal Recording and Playback"
, ➝
page 38 "Synchronous Playback" page
48
)
◆ NOTE:
• This machine does not support VIERA link.
Connecting it to a VIERA link compatible
device with an HDMI cable may cause
VIERA link to malfunction on that device.
8.
REMOTE connector
Connect to an external controller to remotely
control the unit.
◆ NOTE:
• Use double-shielded cable for
connections.
9.
LINK(D) connector
Use this connector to link two units for 3D
REC/PB and SYNC PB modes.
➝
( "3D Signal Recording and Playback"
➝
page 38, "Synchronous Playback" page
48)
◆ NOTE:
• Use a double-shielded RS-422A cable not
longer than 1 m long for connection.
10.
KEYBOARD port (USB 2.0 Type A)
Connect an external USB keyboard to enter
meta data.
(➝ "Using a Keyboard" Vol. 2, page 80)
11.
LINK(M) port (USB 2.0 Type A)
➝
( "3D Signal Recording and Playback"
➝
page 38, "Synchronous Playback" page
48)
◆ NOTE:
• Use double-shielded cable for
connections.
12.
USB2.0 device/LINK(S) port (Type B)
➝
( "USB Device" page 37,
Recording and Playback" page 38,
"Synchronous Playback" page 48)
◆ NOTE:
• Use double-shielded cable for
connections.
13.
Battery latch release button
"Using a battery" page 25
(➝
14.
Power supply/battery mounting location
"Power Preparations" page 25
(➝
Control Reference Guide: I/O Connectors
➝
"3D Signal
➝
)
)
23