Dell GX280DT - GX280 Desktop Computer User Manual page 12

Remote Wakeup-
capable modem
receives a wake up
signal.
Off is the default
setting.
On w/ Boot to NIC
will allow the
computer to
attempt to boot
from a network prior
Remote to using the boot
sequence.
Wake-Up
NOTE: Normally, the
system can be
powered up
remotely from
suspend mode,
hibernate mode, or
when powered off.
When Low Power
Mode (in the Power
Management menu)
is enabled, the
system can only be
powered up
remotely from
Suspend.
The options are S1,
a suspend state
where the computer
is running in a low-
power mode, and
S3, a standby state
Suspend
where the power is
Mode
reduced or turned
off for most
components,
however, system
memory remains
active.
Maintenance
This setting will
restore the
computer's factory-
installed default
CMOS
settings. The
Defaults
options are Cancel
and
Continue/Reset
CMOS.
Displays the system
Event Log
event log.
Select the location
of the BIOS update
BIOS
file. The options are
Update
Floppy Disk or
Hard Drive.
Video
This setting
specifies which
video controller is
Primary
primary when two
Video
video controllers are
present on the
computer.
POST Behavior
When set to On
(default), your
computer will start
Fastboot more quickly since it
will skip certain
configurations and
tests.
This option involves
the rightmost bank
of keys on your
keyboard. When set
to On (default), this
option activates the
numeric and
Numlock mathematical
features shown at
Key
the top of each key.
When set to Off,
this option activates
the cursor-control