HP Tc2120 - Server - 256 MB RAM Installation Manual page 3

Chapter 8
NOTE
Unfortunately, the Windows Server 2003 setup only gives you
a very short time to press F6. If you missed it, you will need to
reboot your system and resume from step 1 above.
4. If you are installing to the Promise FastTrak100 TX2 IDE RAID card do the
following, if not skip to step 5:
a. Press S to specify additional IDE adapters.
b. When prompted, insert the Promise IDE RAID driver diskette you created
from the tc2120 startup CD.
c. Press Enter to continue.
d. Select the Promise FastTrack100 TX2™ Controller adapter, and then
press Enter.
5. If you are installing the Adaptec SCSI RAID 2100S card do the following, if
not skip to step 6:
a. Press S to specify additional adapters.
b. When prompted, insert the SCSI RAID driver diskette you created from
the tc2120 startup CD.
c. Press Enter to continue.
d. Select the Adaptec I2O RAID Host Adapters, and then press Enter.
6. If you are installing to the Adaptec 29160 PCI card do the following, if not
skip to step 7:
a. Press S to specify additional adapters.
b. When prompted, insert the AHA 29160 driver diskette you created from
the tc2120 startup CD.
c. Press Enter to continue.
d. Select the Adaptec Ultra160 Family PCI SCSI Controller, and then press
Enter.
7. Press Enter to continue at the "Windows Server 2003 Setup - Welcome to
Setup" Screen.
8. Press F8 to accept the licensing agreement.
9. At the drives partitioning screen, select the target drive. If you want to use
the entire drive to install Windows Server 2003 then press Enter. Otherwise,
press C to create a partition.
In this example we will create a 4GB partition.
Installing Microsoft Windows Server 2003
3