Section 1. Create The Drivers Diskettes; Section 2. Perform Windows Server 2003 Installation - HP Tc2120 - Server - 256 MB RAM Installation Manual

Chapter 8
2. Install the ATA RAID controller into PCI slot 1 and connect the IDE drives.
3. Turn on the system.
4. Press F10 to enter Setup.
5. Select Boot from the menu.
6. Select Boot Device Priority.
7. Select SCSI Hard Drive and press Enter.
8. Select Promise Fast Track Raid Controller \ HDD 0 and press Enter.
9. Press F6 to Save and Exit. Your system is now ready to use the ATA RAID
controller, but SCSI devices will not be functional.
10. On boot, press Crtl-F to enter the IDE RAID Configuration Utility and
configure the IDE array as usual. Please refer to the Fast Track 100
Reference guide off of
on array configuration.

Section 1. Create the Drivers Diskettes

1. Insert a blank, formatted 3.5" diskette into a the floppy drive of a PC running
Microsoft Windows.
2. Insert your HP Startup CD into the PC's CD-ROM drive and follow the on-
screen instructions to create the appropriate Windows Server 2003 drivers
diskette.
NOTE
If the Windows PC does not auto-start the Startup menu, start it
by opening Startup.htm found at the root level of the
Startup CD.
Section 2. Perform Windows Server 2003
Installation
1. Boot your new server from the Windows Server 2003 CD-ROM.
2. You will see a message that reads, "Setup is inspecting your
hardware configuration". The setup screen will be displayed.
3. The system will briefly show at the bottom of the display "Press F6 if
you need to install a third party SCSI or RAID
controller".
2
Installing Microsoft Windows Server 2003
http://www.promise.com/ for additional information