Battery Maintenance - Lenovo ThinkPad L410 Deployment Manual

Table 3. Global Power Setting (continued)
Policy settings

Battery Maintenance

The Battery Maintenance policy enables you to configure the battery maintenance settings.
To configure the Battery Maintenance policy, do the following:
• For Windows XP client computers (ADM and ADMX files)
Under Computer Configuration, click Administrative Templates ➙ Lenovo ThinkVantage
Components ➙ Power Manager ➙ Battery Maintenance.
• For Windows Vista or Windows 7 client computers (ADM file)
Under Computer Configuration, click Administrative Templates ➙ Classic Administrative Templates
➙ Lenovo ThinkVantage Components ➙ Power Manager for Vista/7 ➙ Battery Maintenance.
• For Windows Vista or Windows 7 client computers (ADMX file)
Under Computer Configuration, click Administrative Templates ➙ Lenovo ThinkVantage
Components ➙ Power Manager for Vista/7 ➙ Battery Maintenance.
This table provides detailed information about each policy setting.
Table 4. Battery Maintenance
Policy settings
Battery charge thresholds
Battery charge modes
36
Power ManagerDeployment Guide
Description
not support monitors with a brightness level higher
than 100.
2. This setting is not supported on Windows XP client
computers.
Description
Specifies the battery charge thresholds.
This policy applied to normal batteries only.
Possible charge thresholds include:
• Always fully charge (Start when below 96%; stop at
100%)
• Optimize for battery lifespan (automatically change for
me)
Note: If you select this option, the Notify me when
thresholds change setting is available for selection.
• Custom
Note: If you select this option, the value in the Stop
charging at spinbox must be set at least 4% above
the value of the Start charging when below spinbox.
Otherwise, you will deploy the Always fully charge
(Start when below 96%; stop at 100%) setting to the
client computers.
Specifies the battery charge modes.
This policy apply to dual mode batteries only.
Possible charge modes include: