Sanyo Network Board MD13NET Owner's Manual page 67

3
The following window will appear. Type as follows and then press the Connect
button.
4
When communication is established, the word "PASSWORD:" appears on the
window. Type the login password* for the projector and then press the "Enter"
key on the keyboard. If you do not register the login password, just press the
"Enter" key.
When the word "Hello" is replied, login has been successful.
5
Type the commands from the key board to control the external equipment and
then enter the "Enter" key for termination. For example, type "C00" and enter the
"Enter" key. The projector will be turned on. The "C00" is a command to turn the
projector on.
To disconnect the communication, select the Disconnect sub menu from the
Connect pulldown menu. To quit the telnet application, select the Quit telnet sub
menu from the Connect menu.
* The password is a login password decided on page 17 or 30. If the authentication of the
entered password is failed 4 times continuously, the communication will be disconnected
automatically. Please try again for the connection.
Host name : 192.168.0.2
(type projector IP address)
Port : telnet or 23
Terminal type : vt100
For example, entering password [1234]
Use of telnet
67
Network Board
OWNER'S MANUAL