Medium room 120v portable air conditioner.
medium room 120v portable air conditioner with 11000 btu heater (28 pages)
Summary of Contents for EdgeStar AP10000HW
Page 1
AP10000H W Portable Air Conditioner Owner’s Manual This owner’s manual provides instructions on safe installation use, and maintenance. Please read it carefully and save it for reference...
2. Press the TEST button on the LCDI plug. This should cut the power to the air conditioner. 3. Press the RESET button to start using your air conditioner. If the indicator light remains lit after pressing the TEST button, please contact EdgeStar support. DO NOT USE YOUR PORTABLE AIR CONDITIONER IF THE TEST FAILS.
Operation Using the Control Panel... 10 Using the Remote Control...12 Adjusting the Louvers...12 Maintenance Water Drainage... 13 Extending the Drain Tube... 14 Cleaning the Unit... 15 Preparation for Storage... 15 Optimizing Performance... 16 Troubleshooting...17 Specifications...18 EdgeStar Limited Warranty Information... 19...
Introduction Thank you for purchasing this EdgeStar portable air conditioner. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship.
Parts Identification Front Display Control panel Buttons Front air vent Handle Caster Accessories 13. Flat adapter - for insertion over hose and into window kit. 14. Exhaust hose 15. Active carbon filter 16. Extendable window kit 17. Drain tube for continuous drainage 18.
Installation – Activated Carbon Filter Instructions to install the carbon filter Remove the pre-filter frame from the unit. Remove the activated carbon filter from its plastic bag. Place the activated carbon filter on the back of the unit. Install the pre-filter frame to the unit.
Note: Take care to secure your window against intruders. 2. Thread the exhaust hose to the air outlet of the portable air conditioner. 3. Thread the oval adapter to the exhaust hose. 4. Attach the oval adapter to the window kit.
Page 9
Installation – Exhaust Hose Use the hose provided and attach the exhaust hose to the back of the air conditioner. Avoid kinks and bends in the exhaust hose as this will cause the unit to work less efficiently. Improper setup may cause the unit to overheat and shut off.
Operation – Using the Control Panel Control Panel Parts Power button Timer button Timer operation indicator Temperature up button Compressor indicator Water Full indicator Temperature down button Low fan speed indicator Turning the Unit On or Off Press the Power button and the unit will start in auto mode. If the ambient temperature is: - Higher than 74 F, the unit will operate in cooling mode.
Page 11
Operation – Using the Control Panel Setting the Temperature Press the ‘Up’ or ‘Down‘ buttons to set the temperature you desire. The display window will show the temperature you set as you press the 'Up' or ‘Down' buttons. Otherwise, it will always show the ambient temperature. The default temperature of this machine is: 75 Note: Temperature control only works in cooling and heating modes.
Operation – Using the Remote Control Operation – Adjusting the Louvers Regulating air flow direction NOTICE ! To prolong the compressor's life, please wait at least 3 minutes before turning the unit back on after shutting it off. The cooling system will shut off if the ambient temperature is lower than the set one. The fan, however, keeps working on the set level.
Maintenance – Water Drainage This portable air conditioner is designed to exhaust most or all water dehumidified from the air. In high humidity situations, the internal water reservoir may fill. If the reservoir is full, both the compressor and motor will stop and the unit will buzz a warning (you can press any button to stop the buzzing).
Maintenance – Extending the Drain Tube The drain tube may be extended by adding an extension tube and using a suitable connector. Please note The drain must be at or below the outlet level. Flashing Comp / Water indicator will not function in this mode of drainage.
Maintenance – Cleaning the Unit Always unplug the air conditioner from the power outlet before cleaning. Clean the air conditioner regularly to maximize performance and efficiency. Cleaning the unit Use a soft damp cloth to wipe the body clean. Use a soft bristle brush to clean between the control panel’s buttons.
Optimizing Performance For Maximum Performance and Efficiency: 1. Do not cover the air outlet (exhaust) while in use. 2. Do not place the unit in front of curtains or drapes- to ensure they do not obstruct the air intake. 3. Minimize the length of the exhaust hose. 4.
- Move the unit to another outlet or unplug the unit, wait for a couple of minutes, and plug it in. - The air conditioner may be plugged into an outlet that can not supply the correct amount of current. Plug the unit in a different room and test. If this works, contact an electrician about the outlet that is not supplying enough current.
Power / Ampere Consumption for heating Maximum Dehumidifying Capacity Refrigerant Fan speeds Timer Net Weight Dimensions EdgeStar Portable Air Conditioner AP10000HW 115 V, 60 Hz 830W / 7.9 A 920W / 8.2 A 50 pints/day R22/15.2 OZ 2 (High and Low) 1- 12 hours 51 lbs.
All defective product components covered by this warranty will be repaired or replaced, at EdgeStar’s option, free of charge on a mail-in basis to EdgeStar’s authorized repair facility during the first 90 days from the date of original purchase. All defective product components covered by this warranty will be repaired or replaced, at EdgeStar’s option, on a mail-in basis to EdgeStar’s authorized repair facility during the time period...
Page 21
For product guides, additional troubleshooting resources, and up to date information, visit us on the web at: http://www.edgestar.com EdgeStar Products Box 81336 Austin, TX 78708-1336 Toll Free: 1-866-319-5473...
Need help?
Do you have a question about the AP10000HW and is the answer not in the manual?
Questions and answers