Table of Contents
Advertisement
Installation
Installation for speakers
You can enjoy 5.1ch surround reproduction by
connecting this 3.1ch speaker system with the AX-7
system. Please set it up as follows.
FSL
SW
L
SL
L
: Front left speaker
FSL
: Front left surround speaker
C
: Center speaker
R
: Front right speaker
FSR
: Front right surround speaker
SR
: Right surround speaker
SL
: Left surround speaker
SW
: Subwoofer
¶ Place the left and right speakers at each side
of your TV. Angle the speakers towards the
listening area to enhance the stereo effect.
¶ Place the center speaker on the center
between the front left and right speakers.
Tilt the speaker upward or downward so that
it is directly facing the listening area.
¶ Place the surround speakers as high as
possible, either directly to the sides of the
listening area or else slightly behind the
listening area. Adjust the angles so that
these speakers are facing directly towards
the listeners.
About using speakers near a TV
(Front speaker, Center speaker)
This speaker include magnetic shielding and can
therefore be installed close to a TV set. Note, however,
that placing speakers too close to a TV may in some
cases produces distortion in the color reception.
6
EN
FSR
R
SR
C
¶ In such case, turn on the TV and check that color
reproduction is normal. If color is distorted,
turn the TV off for 15 to 30 minutes, then turn it
back on and check again. (This allows the TV's
degaussing circuitry to correct for the magnetic
field from the speakers.) If distortion is still
present, move the speakers further from the TV.
Attaching the cushions
(Surround speaker, Center speaker)
¶ Attach cushions to the base of the speaker
as shown below. The cushions prevent
the speaker from sliding, and dampen its
vibrations.
Surround speaker
Using speakers on the desktop or
shelf
¶ Place the speakers on the desktop, shelf or a
similar level surface.
Center speaker
Advertisement
Table of Contents
