Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood KRF-V5100D Instruction Manual

Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
SPEAKERS
ON/OFF ON/STANDBY
POWER AUTO/MONO
ON/OFF
Turning on this model
1 Turn on the power to the related components.
2 Turn on the power to this model by pressing the POWER ON/
OFF and ON/STANDBY
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD/6CH INPUT jacks, make sure that the input mode setting is correct
for the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is "TAPE". To change the
source to "MD", follow the steps below:
1 Use the INPUT SELECTOR knob to select "TAPE".
2 Hold down the AUTO/MONO key for more than 2 seconds.
• The source indication changes to "MD".
• To return to the original indication, repeat procedure 2.
Setting the speaker status
The speaker indicator lights up.
Press the SPEAKERS ON/OFF key to switch the speaker on or off.
INPUT SELECTOR
key.

Listening to a source component

Selector
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
8
The input sources change as shown below:
1 Tuner (FM/AM broadcast reception)
2 "CD/DVD"
3 "TAPE" or "MD"
4 "VIDEO1"
5 "VIDEO2"
6 "DVD/6CH"
7 "AUX"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME % / fi keys to
adjust the volume.
VOLUME CONTROL
INPUT SELECTOR
Input
VOLUME %/fi
19 EN