Canon 3303B002 User Manual page 77

MEMORY FULL
Cause
The fax's memory is full because it has
received too many documents, or a
very long or detailed document.
The fax's memory is full because you
either tried to send or copy too many
pages at once, or you tried to send or
copy a very long or detailed document,
using memory sending.
NO INK
Cause
Ink has run out.
NO TEL #
Cause
The one-touch speed dialing button or
coded speed dialing code you entered
has not been registered.
REC'D IN MEMORY
Cause
The fax received the document in
memory because paper or ink ran out,
a paper jam occurred, or the incorrect
FINE Cartridge was installed.
The fax receives documents in memory
because the <AUTO PRINT> setting is
set to <OFF>.
RECOMEND NEW CRT
Cause
Ink is low.
REMOVE DOCUMENT
Cause
The document is set while printing.
SET DOCUMENT IN CORRECT POSITION
Cause
The document cannot be correctly
detected or the document is too small.
TX/RX CANCELLED
Cause
You pressed [Stop/Reset] to cancel the
transmission.
76 Troubleshooting
Print and delete any documents stored in memory (see page 39). Then start
again.
Free up space in the fax's memory by printing or deleting any documents in
memory you no longer need (see page 39).
If multiple pages are loaded, separate the pages into smaller stacks. If not, try
sending the document by direct sending (see page 24).
Replace the FINE Cartridge (see page 50).
Register the one-touch speed dialing button or coded speed dialing code (see
page 18).
Load paper in the Rear Tray (see your setup sheet or page 22), replace the
FINE Cartridge (see page 50) or clear the paper jam (see page 60).
Print any documents stored in memory (see page 39).
Set the <AUTO PRINT> setting to <ON>. This enables to print received faxes
automatically (see page 37).
Replace the FINE Cartridge (see page 50).
Remove the document. Press [Stop/Reset] and try printing again.
Make sure the document meets the requirements and is correctly loaded. If
necessary, reload the document and press [Start/Copy]. See "Document
Requirements" on page 20 and "Loading Documents and Paper" on page 22.
If required, try sending again.
Action
Action
Action
Action
Action
Action
Action
Action