Ac Power Connection - Sharp Aquos AN-ACS1U Operation Manual

AC power connection

Connecting the AC power cord
After checking that all the connections have been made correctly, connect the AC power cord to the AC outlet.
Rear panel (amplifier part)
To turn the power on
To turn the power on:
Press POWER on the remote control or the main unit.
• The power indicator lights up green.
• If the power does not turn on, check whether the power
cord is plugged in properly.
To set the unit to the stand-by mode:
Press POWER again.
• The power indicator lights up red.
NOTE
• After power-on, there is a mute interval of 8 seconds.
• After the unit enters the stand-by mode, wait a few seconds to turn on again.
16
NOTE
• When connecting the power cords of the various components, plug in the
power cord of the TV last.
• If you have connected or disconnected an HDMI cable or have changed
connections, cycle power to the TV (turn it off and then again) while power to all
other components is on.
• Never use a power cord other than the one supplied. Otherwise, a malfunction
or an accident may occur.
• Unplug the AC power cord from the AC outlet if the unit will not be in use for a
AC120V
60Hz prolonged period of time.
To AC outlet
• Always turn power off before disconnecting a power cord. Always grasp the
plug and do not pull on the cable, as this can lead to cable break.
Power indicator
lights up in red.
Lit in red
Lit in green Lit in green
Lit in red Lit in red