Lcd Screen Safety - Epson WorkForce WF-3520 Quick Manual

■
Leave enough room around the product for sufficient ventilation. Make sure the product is at
least 4 inches (10 cm) away from the wall.
■
Do not block or cover openings in the product case or insert objects through the slots.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the document table when placing the originals.
■
Do not open the scanner section while the product is copying, printing, scanning, or faxing.
■
Be careful not to trap your fingers when closing the scanner cover or scanner.
■
Do not touch the flat white cable inside the product.
■
Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
■
Adjust only those controls that are covered by the operating instructions. Except as specifically
explained in your documentation, do not attempt to service the product yourself.
■
Never disassemble, modify, or attempt to repair the product by yourself, except as specifically
explained in the documentation. Do not adjust controls that are not covered by the operating
instructions.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
■
To avoid adversely affecting the operation of the following equipment and causing an accident,
do not use the product: near medical equipment in a medical facility; within 8.7 inches (22 cm)
of a cardiac pacemaker; near automatically controlled devices, such as automatic doors or fire
alarms.
■
Always keep this guide handy.

LCD Screen Safety

■
Use only a dry, soft cloth to clean the touch screen. Do not use liquid or chemical cleansers.
■
If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on your hands,
wash them thoroughly with soap and water. If the liquid crystal solution gets into your eyes,
flush them immediately with water. If discomfort or vision problems remain after a thorough
flushing, see a doctor immediately.
■
The exterior cover of the LCD screen could break if it receives a heavy impact. Contact Epson
if the panel surface chips or cracks, and do not touch or attempt to remove the broken pieces.
■
Condensation inside the panel due to abrupt changes in temperature or humidity may cause
performance to deteriorate.
36
Important Safety Instructions