Epson P-2000 - Multimedia Storage Viewer Product Support Bulletin page 19

5. Press and hold down the "OK" button while sliding the "POWER" switch as shown
below.
Release the Power switch and continue holding down the OK button until the message
below appears on the screen.
Note: If you do not see this screen, power off the unit and start the firmware process
again.
6. During the update process, the message screen will display the current firmware and
updated firmware versions. Then the message "Updating Resources" will appear.
Note: Do not remove the battery or disconnect the AC adapter during the firmware
process.
7. The firmware process is completed when you see the message "Resources Updated
Successfully" displayed on the screen. See message screen on next page.
Page 4 of 5
PSB.2005.03.001R4