Install Drive - All Servers; Other Servers; Attaching Locating Screws In A Typical Hp Proliant 350 Or 370 - HP DW017B - StorageWorks Ultrium 448 Tape Drive User Manual

1. 6 mm M3 mounting screws
2. 6 mm M3 offset mounting screws
Figure 6 Attaching locating screws in a typical HP ProLiant 350 or 370

Other servers

Attach the appropriate mounting hardware. Refer to the manufacturer's documentation for instructions.
• If you are installing on a server that requires a tray, place the tape drive in the tray.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed
and attached to the tape drive with screws.

Install drive - all servers

NOTE:
If cable access for the tape drive bay is awkward, it may be easier to access power and other connections
if the tape drive is installed in the top bay. You may need to move other devices to lower bays to achieve
this. Refer also to your server documentation.
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as shown in
Figure 7 on page 26.
Ultrium half-height SAS Tape Drives
25