Cable Tie; Torx Tools; Preparing To Install The Hard Disk Drive - HP 6000 330s Owner's Manual

HP Series 6000
Models 330S and 660S
Cable Tie
The cable tie is for wrapping the power cables in place once
the new SCSI device is installed.
TORX Tools
The TORX tools are used to drive TORX screws.
Preparing to Install the Hard Disk Drive
Before installing a hard disk drive, make sure you have
access to all sides of the mass storage system, and that the
mass storage system is near an ac power outlet.
1. Shut down the host computer.
2. Turn off power to both the host computer and the mass
storage system.
3. Disconnect the SCSI cable from the mass storage system.
4. With the
(LlNE- )
switch in the 0 (out) position, connect
the power cord from the mass storage system rear panel
to an ac power outlet.
5. Place the rear of the mass storage system chassis on the
conductive sheet as shown in Figure 2-2.
6. Wrap one end of the wrist ground strap around your
wrist and apply the copper end to a flat, unpainted area
of the mass storage system chassis. The mass storage
system chassis, the conductive sheet, and your hand are
now at the same electrical potential.
Keep the wrist strap on until you have performed all the
steps in the installation procedure.
7. Slide the foam pad beneath the conductive sheet, while
making sure the mass storage system chassis maintains
contact with the conductive sheet.
Hard Disk Drive 2-11