Dell PowerEdge 180AS User Manual page 48

2 Attach one end of the CAT 5 cabling that will run between your PEM
and the Remote Console Switch unit to the RJ-45 connector slightly
separated from the other connectors on the PEM. Connect the
remaining end of the CAT 5 cable to the desired ARI port on the back of
your Remote Console Switch unit.
3 To one of the eight RJ-45 connectors grouped on the back of the PEM,
attach the CAT 5 cabling that will run between your PEM and each
device's SIP.
4 Connect the other end of the CAT 5 cable to the first of the SIPs.
5 Repeat steps 3-4 for all devices you wish to attach.
Figure 2-14. Remote Console Switch Configuration With a PEM
Analog User
Table 2-4. Remote Console Switch Configuration With a PEM Descriptions
Number
1
31
Installation
1
Description
ARI Port
2
3
4
5