GE NX-1448E - Security NetworX 48-Zone Fixed User Manual page 19

ICON
1
2
3
4
5
6
7
8
Step 5 Press the [r] key. The ready icon is on constant and instant icon
is on constant. This moves you to the partition enable. (The user
has access in partitions that are illuminated.)
Step 6 The illuminated numbers indicate each partition where the user
has access. To change any of the partitions where the user has
access, press numbers corresponding to areas where you want to
give the user access or deny access. (Example: If zone icon #2
is lit, then the user is assigned access to partition #2. By
pressing the [2] key, the icon will go off, denying access to
partition #2. Refer to the following chart.
NX1448E Icon Keypad
AUTHORITY LEVELS IF ICON 8 IS OFF
Reserved (Note: Do not change if on.)
Arm Only
Arm Only After Closing Time
Master Arm/Disarm (can program other codes)
Arm/Disarm
Bypass Zones
Open / Close Reporting
If this icon is on, this code is programmed as a
function code. Do not change! Press [#] - [#] to exit.
ICON PARTITIONS ASSIGNED
1
2
3
4
5
6
7
8
Partition 1
Partition 2
Partition 3
Partition 4
Partition 5
Partition 6
Partition 7
Partition 8
Page 19