HP x280n - MediaSmart Connect - Digital Multimedia Receiver Installation And User Manual page 48

6 Enter the first four-digit code for your manufacturer from the
listing. If the code is accepted, the device indicator light
blinks twice. If the code is not accepted, the device indicator
light blinks three times.
n
If the device indicator light did not blink twice, repeat
steps 5 and 6, entering either the same code or the next
code, if there is one.
7 Point the remote control at the secondary device, and then
press the Mute button. The sound should mute. If it does not,
repeat steps 5 and 6, trying each code for your brand until
you find one that works.
8 Repeat these steps for each primary device you want to
program for volume mapping.
This completes programming a second device for volume
mapping.
Chapter 3: Using the Remote Control
Programming the device code by using
auto setup mode
If your home entertainment device does not respond to the remote
control after you try all the codes listed for your brand, try
searching for your code by using these steps for auto setup mode:
1 Turn on the device you want to program.
2 Press the Device button on the remote control one or more
times to select the device you want to program (TV, CBL,
DVD, or AUX). Wait until the device indicator light on the
remote control goes out.
3 Press and hold down the Device button on the remote control
for 5 seconds, until the device light blinks, and then release
the Device button. The device light blinks one more time and
then remains lit, indicating the remote control is in
programming mode.
4 Enter 8, 8, 8, 8. The device indicator light blinks once and
then remains lit.
48