GE AJCQ08AC Owner's Manual page 6

About the controls on the air conditioner-Heat/Coo! Modds
Appearance may vary.
ON
® OFF
TIMER
't
® COOL
Q FAN
® HEAT
TEMP
Q HiGH
• Low
,
Air Conditioner Controls
Lights beside the touch pads on the air conditioner
control panel indicate the selected settings.
ON/OFF
__J
Remote Control
Controls
O ONIOFF
Turns air conditioner on and off.
O isplag
Displagsthe temperature setting. Displags
hours when setting the timer.
@
O
0
MODE
On the air conditioner controls, use to set
COOL,HEATor FAN mode. Indicator lights
on the air conditioner controls will show the
mode selected.
TEMP Increase +/Decrease - Pads
Use to set temperature when in COOL
or HEATmode.
FAN Speeds
Use to set the fan speed at LOW or HIGH.
Indicator lights will show the speed selected.
O
0
TIMER
ON--When the air conditioner is off, it can
be setto automaticallg turn on in half an
hour to 24 hours at its previous setting.
Eachtouch will set the time in half hours
up to 10 and then in hours up to 24.
To cancel the On Timer,press the ON pad
until the displag time disappears.
OFF--When the air conditioner is on, it can
be set to automaticallg turn off in half an
hour to 24 hours. Eachtouch will set the
time in half hours up to 10 and then in hours
up to 24.
To cancel the Off Timer,press the OFFpad
until the displag time disappears.
Remote Control Signal Receiver
NOTE:When the air conditioner is turned on,
it will automaticallg start in the setting last used.
Remote Control
To ensure proper operation, aim the
remote control at the signal receiver
on the air conditioner.
E The remote control signal has a range
of up to 21 feet.
E Make sure nothing is between the air
conditioner and the remote control that could
block the signal.
E Make sure batteries are fresh and installed
correctly-see the Care and Cleaning section.
6