Smartcraft Setup Data And Calibrations - NorthStar SMARTCRAFT GATEWAY Manual

5-6-2 Engine fault history
To display a list of recent engine fault alarms, press
, select SmartCraft, then select En-
gine fault history.
When the Engine fault history is dis-
played
Press or
list.
To display more information about a particu-
lar fault:
i Press or
ii Press
iii Press
list.
To exit the list, press
To clear the engine fault history:
Go to the engine fault history display, press
and select Reset fault his-
tory.

5-7 SmartCraft setup data and calibrations

To go to the SmartCraft setup data and calibrations,
press until the Setup menu is displayed,
then select SmartCraft.
Note:
If there is more than one SmartCraft capable Nav-
man instrument in a system, some setup data may
be different in each instrument.
32
to page up and down the
to select the fault.
to display the information.
or to return to the
.
The setup and calibration options are:
Tanks
Set up and calibrate the tanks (see section 5-7-1).
Troll window
Select from a menu:
On idle: Troll window is displayed when you
press
engine is in gear.
Always: Troll window is displayed when you
press
Never: Troll window never displayed, troll
control is not available.
Troll mode
Select what troll mode controls:
RPM: Controls engine idle RPM.
Speed: Controls engine idle RPM to try to
achieve the desired boat speed.
See section 5-3, notes 1 and 2
Trim
Set up and calibrate the trim display (see section 5-7-2).
NAVMAN
SmartCraft gateways Installation and Operation Manual
and the throttle is at idle and the
.