Operation With A Navman Trackfish 6600 - NorthStar SMARTCRAFT GATEWAY Manual

4 Operation with a Navman TRACKFISH 6600

Before a SmartCraft gateway is connected, the TRACKFISH 6600 functions normally, with no SmartCraft
functions. When a SmartCraft gateway is connected and SmartCraft is turned On (see section 4-1),
SmartCraft functions become available and some standard functions change.
SmartCraft functions
Data displays
Engine performance and tank level displays ............................................................................................. See section 4-2
Troll control
Automatically maintains a set engine idle RPM or idle boat speed ................................................ See section 4-3
Trim indicator
Displays the trim angle when engine trim is adjusted .......................................................................... See section 4-4
Alarms
Engine fault alarms ............................................................................................................................................... See section 4-5
Engine fault list, a list of active SmartCraft engine fault alarms ......................................................... See section 4-6
Engine fault history, a list of past SmartCraft engine fault alarms .................................................... See section 4-6
Tank low level alarms .......................................................................................................................................See section 4-2-1
Setup data and calibrations
SmartCraft setup data ......................................................................................................................See sections 4-1 and 4-2
SmartCraft calibrations, Tanks, Trim and Steering angle ....................................................................... See section 4-7
SmartCraft setup data and calibrations .....................................................................................See sections 4-7 and 4-1
The SmartCraft data available depends on the engine type and the sensors fitted (see section 1-1).
Changes to standard functions with SmartCraft enabled:
key: When using troll control, pressing
second time to display the normal menu.
Fuel: The fuel display functions normally but with fuel and speed data coming from the SmartCraft
system rather than from separate sensors connected to the TRACKFISH 6600.
If there are no optional level sensor(s) fitted to the fuel tanks (see section 1-1-1), then the Smartcraft
fuel flow is used to calculate fuel remaining. The fuel setup data is the same as the standard TRACK-
FISH 6600. You must tell the TRACKFISH 6600 when you add or remove fuel (see the TRACKFISH 6600
Installation and Operation manual).
If each fuel tank has an optional level sensor fitted (see section 1-1-1), then these tank levels are used
to calculate fuel remaining. In the Fuel display, Used changes to Trip used, and the only fuel
setup option is Clear trip used. Trip used measures the volume of fuel used until it is reset
to zero by selecting Clear trip used in the fuel setup menu. You do not tell the TRACKFISH
6600 when you add or remove fuel.
Engine hours: Engine hours on the Log display come from the SmartCraft system.
It can not be reset.
Simulate mode: Data from the SmartCraft engine(s) and sensors is simulated. The SmartCraft data
simulated will probably differ from the data available in your system.
For more information, see the TRACKFISH 6600 Installation and Operation manual.
18
can display the troll window. Press
NAVMAN
SmartCraft gateways Installation and Operation Manual
a