Setting Up The Trackfish 6600 For Smartcraft; Smartcraft Engine Data Displays - NorthStar SMARTCRAFT GATEWAY Manual

4-1 Setting up the TRACKFISH 6600 for Smartcraft

There are two SmartCraft items in the TRACKFISH
6600 System setup menu. To display the System
menu, press
played, then select System.
Sonar
Select: For normal sonar operation
De-select: To disable the sonar transducer
and sonar functions. For use
with the instrument's SmartCraft
functions only,
SmartCraft
Select: Normal SmartCraft operation
De-select: SmartCraft functions. The instru-
ment will now use any Navman fuel
sen sors which are connected.

4-2 SmartCraft engine data displays

There are four SmartCraft engine displays, shown below.
Note: If the boat has twin engines, two needles will appear on most of the gauge displays. The red needle
or number shows port engine data, green shows starboard engine data.
Data header display area
Small: Eight small gauges
Diagnostics: Shows
eight small gauges.
Press , select
SmartCraft, then
select Diagnostics.
SmartCraft gateways Installation and Operation Manual
until the Setup menu is dis-
Engine data display area
Medium: Two medium, four
small gauges
Cruising: Shows two
large and four small
gauges. Press
, select SmartCraft,
then select Cruis-
ing.
Note:
SmartCraft utilises NavBus comms. NavBus will
turn on if SmartCraft is turned on.
Large: Two large gauges
Engine data large:
Shows two large
gauges. To display this,
press , select
SmartCraft, then
select Engine data
large.
NAVMAN
Tanks: Tank levels
Tank status: Shows
the levels in the tanks.
To display this, press
, select
SmartCraft, then
select Tank status.
19