NorthStar 6 KW RADAR Installation Manual page 31

where:
Key
A
B
C
D
E
F
G
The radar processor has two remote power inputs with opposite active states which are OR'ed
together.
Pin 10 input (active low) is used by the 6000i or 6100i systems and Pin 12 input (active high) is used
by the 8000i system.
Pin 12 is tied to ground through the NS003107 cable, to allow control through Pin 10.
The radar processor has an active low input with a pullup resistor to Vbatt, to complement the open
collector output configuration of the 6000i or 6100i systems.
There is a choice of two different modes for powering the radar ON/OFF:
If you want the radar to power ON automatically when the radar processor is powered ON,
connect the White/Orange wire to a NMEA ground in the junction box.
If you want the radar to power ON automatically whenever the 6000i or 6100i is ON,
program the Honk Output as REMOTE PWR in the 6000i or 6100i. This option is contained in
the Alarms menu. (To access the Alarms menu, repeatedly press the * key until the Alarms
menu is visible.) You must also connect the Pink wire to the White/Orange wire in the
junction box.
Northstar 6 kW Radar Installation Manual
Component
Radar processor
NMEA/Comms port
NMEA port
Link in the junction box
Fuse/Breaker board
Fuse
Battery
25