Table of Contents
Advertisement
4. Tear away the tape (A) as shown, then loosen about the shield mesh and bend this around the washer as
shown.
5. Slacken or remove the strain relief clamp just inside the scanner, close to the cable entry point.
6. Push the interconnection cable through the cable entry point into the scanner. (Ensure that you push through
sufficient cable to easily connect to the J connectors on the lid, as described in the following step.)
7. Connect the four interconnection cable connectors to the four J connectors on the lid, as shown:
16
Connector end B to J302
Connector end C to J202
Connector end D to J201
Connector end E to J209
Northstar 6 kW Radar Installation Manual
Advertisement
Table of Contents
