4 Close the blade. See "Closing the Blade" on page 159.
5 Install the blade. See "Installing a Blade" on page 148.
Figure 3-33. Installing or Removing an iDRAC6 Enterprise Card
3
1
iDRAC6 Enterprise card
3
retention screws (2)
Removing an iDRAC6 Enterprise Card
1 Remove the blade. See "Removing a Blade" on page 145.
2 Open the blade. See "Opening the Blade" on page 149.
3 Remove the iDRAC6 Enterprise card:
Remove the two Torx screws. See Figure 3-33.
a
Lift the card from the system board.
b
NOTE:
You must replace the iDRAC6 Enterprise card before reinstalling the blade.
The blade does not power up without an iDRAC6 Enterprise card installed.
2
2
socket
Installing Blade Components
1
215