Closing The Blade; System Memory; System Memory - Poweredge M910 - Dell 8 Owner's Manual

Closing the Blade

1 Ensure that no tools or parts are left inside the blade.
2 Align the notches in the edges of the enclosure with the cover alignment
pins on the inner sides of the cover.
3 Check that these cover-release latch is fully open, and lower the cover onto
the enclosure.
4 Close the cover-release latch until it is flush with the surface of the cover.

System Memory

System Memory – PowerEdge M910
Your system supports DDR3 registered DIMMs (RDIMMS) only.
32 memory sockets are located on the system board, organized in eight
channels with four DIMMs per channel. This configuration permits the
following maximum memory configurations:
Up to four 2 GB, 4 GB, 8 GB, and 16 GB RDIMMs are supported per channel,
for a total of up to 512 GB. Single-rank, dual rank, and quad-rank RDIMMs
are supported.
Installing Blade Components
159