Dell 8 Owner's Manual page 109

Table 1-26. Blade Messages
Message
128-Bit Advanced
ECC Mode Disabled
- For 128-Bit
Advanced ECC mode,
ECC DIMMs must be
used.
DIMMs must be
installed in
pairs. Pairs must
be matched in size
and geometry
Sparing Mode
Disabled - For
Sparing mode,
matched sets of
three must be
populated across
slots.
The following
DIMM's should
match in size:
in rank count:
in size and rank
count:
in geometry:
in size and
geometry:
Thermal sensor not
detected on
(continued)
Causes
The memory
configuration does not
match the setting in BIOS.
The BIOS setting has been
disabled.
The memory
configuration does not
match the setting in BIOS.
The BIOS setting has been
disabled.
Invalid memory
configuration. The
specified DIMMs do not
match in size, number of
ranks, or number of data
lanes.
Invalid memory
configuration. A
mismatched DIMM is
installed.
Corrective Actions
Reconfigure the memory
modules to support
Advanced ECC mode. See
"System Memory" on
page 159.
Reconfigure the memory
modules for Memory
Sparing mode. See "System
Memory" on page 159.
Ensure that the memory
modules are installed in a
valid configuration. See
"System Memory" on
page 159.
Ensure that the memory
modules are installed in a
valid configuration. See
"System Memory" on
page 159.
About Your System
109