Connecting The Wiring; Mounting The Camera - JVC TK-T2101RU Instructions Manual

Fixed ir dome camera

Hide thumbs Also See for TK-T2101RU:

Table of Contents

INSTALLATION

2.2 Connecting the wiring

Refer to Figure 1-1 to connect the video connect output connector (#b) and 24

VAC/12 VDC power connector (#a).

Caution: For DC power supply use, make sure the polarity is correct to avoid

malfunction and / or camera damage.

1. Attach the mounting template to the wall or ceiling.

2. Drill two holes, then insert the screw anchors (#1) into the holes.

3. Secure the bottom case to the wall or ceiling with the TP4 x 15 mm tapping

screws supplied (#2).

4. To prevent the camera from falling off, ensures it is connected to a firm place

(ceiling slab or channel) using a Safety Wire (fall prevention wire#3 is not

supplied).

Note: Depending on the material of your mounting surface, you may require different

screws and anchors than those supplied.

Plastic Band

Figure 2-2 Camera installation

Safety Wire (fall prevention

wire#3 is not supplied).

Please tighten a safety wire

using plastic band on a firm

place as photo.

1. Screw anchors (x2), supplied

2. TP4 x 15 tapping screws (x2),

supplied

3. Safety Wire(fall prevention

wire, not supplied)

Safety Wire

Table of Contents

Tk-t2101re