JVC C11U - VN Network Camera Instructions Manual page 52

Operations (Step 4 Setting with V.Networks Controller)
4-7 Alarm Setting (continued)
1
Message
When an alarm is received, the message
entered into the text box is displayed. The
maximum number of characters that can be
entered is 100.
2
Recording
When an alarm is received, recording starts.
Non-Stop : Recording continues until the
Stop button is pressed.
Stop 1min : Recording stops after 1 minute.
Note
• The [Stop 1min] mode is for conserving
the hard disk space.
• In this mode, recording stops after 1
minute even if recording has already
started before the alarm input.
Note
Alarm Operation
The following settings are required for the operation of the alarm that has been set.
1. [Alarm Reg] is enabled in the [Setting] menu of the [V.Networks Controller.] (
2. Each alarm setting in [Alarm Setting] of [V.Networks Setup Tool] is enabled. (
Relay Alarm
When the relay alarm function is enabled, subsequent alarms will not be activated.
52
3
Playing wave file
When an alarm is received, a specified Wave
file is replayed. Press the [Browse] button to
specify a Wave file.
Note
If a large Wave file (.wav) is selected, the
alarm operation may become slow depend-
ing on the PC performance.
4
Execute application file
When an alarm is received, a specified
program is executed. Press the [Browse]
button to specify a program.
☞
Page 45)
☞
Page 28)