For Th-42Ph12L, Th-50Ph12L - Panasonic TH-50PH12L Operating Instructions Manual

Connections

For TH-42PH12L, TH-50PH12L

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker
terminal (R)
– AC cord ¿ xing
Note:
Make sure that the AC cord
is locked on both the left and
right sides.
– Cable ¿ xing band
Secure any excess cables with band as required.
Note:
One ¿ xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
¿ xing band through the clip
as shown in the ¿ gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
10
AC cord connection (see page 15)
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
2
it clicks.
2 Fix the AC cord with
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable ¿ xing band around them then
pass the pointed end through the locking block, as shown in the ¿ gure.
While ensuring there is suf¿ cient slack in cables to minimize stress (especially
in the power cord), ¿ rmly bind all cables with the supplied ¿ xing band.
2
R L R L
AUDIO AUDIO VIDEO
S VIDEO
B AV IN A
SLOT2
Dual Video Terminals COMPONENT/RGB IN and
(equivalent of BNC Audio IN Terminals (equivalent
Dual Video Terminal of BNC Component Video
Board (TY-FB9BD)) Terminal Board (TY-42TM6A))
(see page 13) (see page 14)
Speaker
terminal (L)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob
pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L
P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 11)
1
2
2
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet ¿ rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 12)
1