Yamaha CRW2100S - CRW - CD-RW Drive Owner's Manual page 29

8 Connect a 4-pin power cable to the power supply connector of the
CRW2100S drive marked "DC INPUT."
n There may be more than one 4-pin power cable available. Any may be used.
n These connectors are D-shaped so it is only possible to connect the power cables
the correct way round. Do not apply excessive force when making this connection.
9 Tighten the four fastening screws on the side of the unit securely
using a screwdriver.
S C S
I
IN T E
R F A
C O N C E
N E C
T O R
4-pin power cable
Setup Procedures
Top Top op
Bottom
20