Scsi Id Number - Yamaha CRW2100S - CRW - CD-RW Drive Owner's Manual

Setup Procedures

1 SCSI ID Number

Each of the SCSI devices connected to the computer is identified by its SCSI ID
number. You need to assign a number from "0" to "7" for each SCSI device.
Commonly, ID number "7" is reserved for the computer' s SCSI card itself.
Therefore, the CRW2100S drive can actually be assigned an ID number from "0"
to "6." The ID number is set by attaching/detaching the shunts on the ID Select
jumper switches according to the diagram shown below.
SCSI ID 0
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 3 (Default)
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 6
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
n The SCSI ID number for each device on the chain must be unique. Make sure the
CRW2100S drive' s SCSI ID number is not the same as that of any other device on the
chain. By factory default, the CRW2100S drive is assigned ID number "3" but this can
be changed.
n If the SCSI card supports SCAM and SCAM is turned "ON," a different ID number may
be assigned if the SCSI ID number on the rear panel coincides with another SCSI device.
11
SCSI ID 1
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 4
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 7
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 2
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4
SCSI ID 5
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
1 2 4