ITech IT2800 Series User Manual page 162

•
•
•
•
•
Parameter Details
System→Fiber menu described as below:
Trig1_in-
>fiber25
Trig2_in-
>fiber26
Trig3_in-
>fiber27
Trig4_in-
>fiber28
Confirm that synchronization is in a normal state.
This feature cannot be configured in standalone mode; it must be configured
in either master or slave mode.
Open the trigger synchronization feature in the System→Fiber interface.
In normal mode, configure synchronous triggering by navigating to
Config→Advanced Setting→Trigger Source and changing the trigger
source to Fiber.
In Sweep mode, configure synchronous triggering by navigating to
Sweep→Setting→Trigger Setting→Start Trigger Source / Step Source
and changing the trigger source to Fiber.
Parameter
IO1 triggering is converted to Fiber25
trigger signal. Set IO1 as Trig in in Menu >
System > I/O > IO1. When an external
stimulus signal is applied to IO1,
triggering conditions are met, and it is
then converted to a Fiber25 trigger signal.
IO2 triggering is converted to Fiber26
trigger signal. Set IO2 as Trig in in Menu >
System > I/O > IO2. When an external
stimulus signal is applied to IO2,
triggering conditions are met, and it is
then converted to a Fiber26 trigger signal.
IO3 triggering is converted to Fiber27
trigger signal. Set IO3 as Trig in in Menu >
System > I/O > IO3. When an external
stimulus signal is applied to IO3,
triggering conditions are met, and it is
then converted to a Fiber27 trigger signal.
IO4 triggering is converted to Fiber28
trigger signal. Set IO4 as Trig in in Menu >
System > I/O > IO4. When an external
stimulus signal is applied to IO4,
triggering conditions are met, and it is
then converted to a Fiber28 trigger signal.
Copyright © Itech Electronic Co., Ltd.
Description
Function Details
Setting
Range
On: Turn on
Off: Turn off
On: Turn on
Off: Turn off
On: Turn on
Off: Turn off
On: Turn on
Off: Turn off
151