Honeywell Home FocusPRO P200 Series Installation Manual page 16

Installer Test
1. Press and hold the bottom left button and Up arrow
button for 5 seconds to access the
2. Press  or  to cycle through
until you see TEST, then press
3. The display will show the current test mode. To test the
mode displayed, press . If testing Heat or Cooling on
multi-stage equipment, a second press of the
indicate a call for Stage 2.
4. Press NEXT to advance to the next mode in the test menu.
Possible settings in the test menu are Heat, Cool, Em
Heat, Fan
5. Press EXIT after testing is done.
System Test
Shaded areas below apply only to TH2320 models
Heat
Cool
Em Heat
Fan
User Menu Options
After initial setup is complete, you can enter the User menu.
1. Press Menu button
2. Press or to cycle through
 
SELECT.
User menu options
Note: When any Alert or Reminder is active it is the first item displayed under Menu
•
SCHEDULE: Turn schedule on or off or set/edit schedule settings
• APP: Use the app (S200)
• WIFI: On or Off (S200)
•
TEMP: Display outdoor or indoor temperature
• DATE: Set Date
•
TIME: Set Time
• LOCK**: Change lockout status (OFF, FULL or PART). Partial lockout allows temporary setpoint change only.
EXIT
3. To and return to the Home screen, press the
out.
*Outdoor option only shown if ISU 1060 is set to use a wired outdoor sensor or Internet
** Lockout option only shown if ISU 4110 is set to Lockout Enabled
INSTALLER MENU
INSTALLER MENU options
SELECT
 button will
System Status
0 All Off
1 Heat Stage 1 On
2 Heat Stage 2 also On
3 Heat Stage 3 also On
0 All Off
1 Cool Stage 1 On
2 Cool Stage 2 also On
0 All Off
1 Em Heat On
0 Fan Off
1 Fan On
User Menu options. When the menu option you want to use is displayed, press
*
EXIT
button (upper left) or wait for the thermostat to time
16
Hold
MCR39507
Hold
Heat On
MCR39533