AKG HT 40 User Instructions page 12

2 Description
2.1 Introduction
Dear Customer:
Thank you for purchasing an AKG
product. This Manual contains important
instructions for setting up and operating
your equipment. Please take a few
minutes to read the instructions below
carefully before operating the equip-
ment. Please keep the Manual for future
reference. Have fun and impress your
audience!
2.2 Unpacking
1 HT 40 2 AA size
Handheld 1.5 V dry
Transmitter batteries
12
Check that the package contains all the
parts listed above. If anything is missing,
please contact your AKG dealer.
2.3 Optional Accessories
W 880 foam windscreen
2.4 Description
The HT 40 handheld transmitter oper-
ates on one fixed, quartz stabilized fre-
quency in the 710 MHz to 865 MHz UHF
carrier frequency range and uses an
antenna integrated in the body.
The microphone element permanently
mounted on the transmitter is acousti-
cally identical to the D 880 vocal micro-
phone from AKG. This microphone fea-
tures a built-in wind and pop filter to
1 SA 43 stand
reduce wind and breath noise and pro-
adapter,
vides low handling noise sensitivity, high
black color
gain before feedback, and brilliant sound
code clip
quality.
2.5 Controls (See fig. 1 on page 13)
1 On/Off switch: This slide switch
provides three positions indicated
in the display window:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the
microphone element is muted
while power and the RF carrier
frequency remain on. This pre-
vents the receiver from respon-
ding to interference from other
transmitters.
OFF: Power to the transmitter is off.
2 Status LED: Indicates battery status.
LED flashes momentarily upon
switching ON and extinguishes:
batteries are OK.
LED lights constantly: batteries will
be dead in about 50 minutes.
3 Color Code: The color of this plastic
clip indicates the carrier frequency of
your transmitter. Receivers tuned to
the same frequency are marked with