How To Handle The Remote Control - Sanyo NV-E7000 Installation And Operation Manual

HOW TO HANDLE THE REMOTE CONTROL (1)

INSERT BATTERIES IN THE
REMOTE CONTROL
The remote control uses two AAA
batteries.
t CAUTION
¡Align the "+" and "–" terminals
correctly and do not mix an old with a
new battery or two different kinds of
batteries. Otherwise, the batteries may
leak and crack leading to fires and
injury.
¡Batteries cannot be recharged.
¡Installing or leaving the remote control
in direct sunlight such as the
dashboard will cause deformation and
malfunctions. Exercise caution.
¡Spilling water, beverages or solvents
onto the remote control may cause
damage. Exercise caution.
47
1
Press down on the tab and
pull the cover outward.
2
The battery inserted on the
left has its minus terminal
pointing upwards and the
right battery has its plus
terminal pointing upwards.
3
Align the bottom tab of the
cover with the groove on the
remote control and close.
REMOVE THE REMOTE
CONTROL FROM THE HOLDER
1
Push the side tabs on the
holder a bit outwards and
remove.
Tab
Holder
2
Pull it outwards.
RETURNING THE REMOTE
N
CONTROL TO THE HOLDER
T
R
O
1
D
Align the tab on the bottom
U
of the holder with the groove
C
T
on the bottom part of the
remote control.
O
N
Holder
Groove
Tab
2
Push the remote control onto
the holder until the side tabs
snap into place.
48
I
I